Mixed Bed Deionizer

You are here: Home -> Products -> DI Water System -> Mixed Bed Deionizer
E-ROTEK WATER SYSTEMS CO.,LTD is the leading Taiwan manufacturer, supplier and exporter of Mixed Bed Deionizer which are formulated to suit individuals' personal needs. Our range is available in high quantities and at most competitive pricing. We are also capable to offer our entire range as per the requirements of our customers. Our produce is available at very reasonable prices. If you are interested in any styles of our products, please feel free to contact us.
  • Mixed Bed Deionizer - MB


Model: MB
Mixed Bed Deionizer
Mixed Bed Deionizer

ROTEK can design and build bespoke mixed bed polishing units to suit all of our customers'requirements. Cation and Anion resins are combined in a GRP or stainless steel vessel to produce ultra pure water. Usually a mixed bed polishing unit contains strong acid Cation (SAC) resin and strong base Anion (SBA) resins combined to a ratio of approximately 40% Cation resin to 60% Anion resin. (All resin volumes are dependent upon the incoming water analysis and the required quantity of treated water). Mixed bed polishers are typically installed when a water quality of less than 1 micro ohm conductivity is required. Rotek can install mixed bed polishers after a standard Reverse Osmosis or Demineraliser, to produce ultra high quality water. The Cation resins in our mixed bed polishers are of a higher specific gravity and settle at the bottom of the vessel whilst the Anion resin will automatically float to the top.

Please note: The Cation resin must be a strong acid Cation type (SAC) and the Anion resin must be a strong base Anion resin (SBA)

After a service cycle, each resin is regenerated as listed:

(SAC) : Strong Acid Cation resin is washed with approx. 30% hydrochloric acid.
(SBA) : Strong Base Anion is washed with approx. 26% caustic.

Please note: The above regenerate strengths refer to the values before being diluted by the mixed bed polisher educator systems.

Professional Series MIXED BED DEIONIZER

Product Features
  Pre-programmed 9 steps of regeneration procedures.
  Each regeneration procedures timing is adjustable
  P.L.C. control with light indications on a mimic panel
  Resistivity Controller or Conductivity Controller is included.
  Acid and caustic dosing systems.
  Automatic / Manual switches provide flexible controls

Working Conditions
  Working Temperature: 5°C ~ 45°C
  Working Pressure: 30 ~ 60 PSI
  Feed Water Requirements: TDS below 200ppm / pH 6 ~ 8 /
    Organics, Oxide, Chlorine below 1 ppm
  Regeneration Chemicals: 28%HCL / 30%NaOH

Specifications

Model

Flow Rate (M3/HR)

Vessel Size

Exchange Capacity

Resin Capacity (Liters)

Minimum

Maximum

(Inch)

(Grains CaCO3)

Cation

Anion

MB-240-21

4.0

6.0

21 x 62

127000

175

200

MB-240-24

6.0

8.0

24 x 72

190000

250

300

MB-360-30

8.0

12

30 x 72

300000

400

475

MB-360-36

10

15

36 x 72

470000

575

650

MB-360-42

15

20

42 x 72

640000

750

900

MB-360-48

20

25

48 x 72

834000

1000

1200


Enquiry Now +Enquiry Now -
We own a very gifted artisan talent pool which guarantees timely deliveries with top quality

Mixed Bed Deionizer

. We sincerely welcome all relevant friends all over the world to come for visit and cooperation!
Italian, Italiano